How To Install A TV Wall Mount

STEP 1 - Determine The TV Height

The first step is to determine the perfect height we want the TV on the wall. To do this, you will need to measure from the ground, 90 degrees up, to your eye line when sitting on your lounge. If you have a friend handy, it'll be a little easier with them doing the measuring. Take note of this measurement on a notepad. Take note of the size of your TV, the height of the mount, and your furnishings in the area.

STEP 2 - Find The Studs

Now we understand the ideal height we want to place the TV Mount, we need to determine the mounting holes for the wall. If you have a timber frame home, you will have timber wall studs running vertically up your wall, behind the plasterboard. These are typically 450mm or 600mm apart. Once you've found the wall studs using a stud finder, place masking tape vertically up the centre of the wall studs and mark the centre with a pencil at the predetermined eye line height.

STEP 3 - Mark The Mounting Holes

Place the wall bracket in the centre of the marks previously made, level it with a spirit level and mark the mounting holes required. The number of mounting holes will be determined by your TV Mount requirements as vertical mounts start with two required, and horizontal mounts may require four or six depending on the size.

STEP 4 - Drill The Mounting Holes

Make sure to put on any PPE and eye protection then using a power drill and a drill bit slightly smaller than your mounting screws (mounting screws provided with the TV mount), pre-drill the mounting pilot holes.

STEP 5 - Mount The TV Wall Bracket

Using your drill or Phillips screwdriver, secure the wall bracket loosely to the wall with one screw. Check again that the wall bracket is level when lined up with the remaining holes. Make corrections if required and then proceed to screw in the remaining mounting screws.

STEP 6 - Attach The TV Arms

Lay your TV face down on a soft surface. Place the supplied TV arms vertically inline of the VESA Pattern. Position the TV arms so that it doesn't protrude past the size of the TV. Ensure that the hooks are facing down. Using the appropriate sized bolts and washers, ensure that these bolts are firmly secured by hand to the TV but do not over tighten them.

STEP 7 - Mount The TV

With a friend, carefully pick up your TV from each side and place the TV arm hooks onto the wall bracket.

STEP 8 - Secure The TV

The TV arms will have a spring clip that can be clicked into place or have screws that screw into the wall bracket.

STEP 9 - Make Adjustments

If you have a full-motion or tilt motion TV wall mount, you'll have the ability to adjust the mount. Refer to your user manual to understand how to do this.